INSTALLATION REQUIREMENTS
Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Pliers that open to
1 3/4" (44.5 mm)
4" min
(102 mm)
Wood Block
Optional tools:
Flashlight
Parts supplied:
NOTE: All parts supplied for installation are in cardboard insert
in the top of the washer.
Drain hose with clamp,
U-form, and cable tie
Parts needed (Not supplied with washer):
Inlet hoses with
flat washers
2
Level
Ruler or measuring tape
Bucket
To order, please refer to the toll-free phone numbers on the
back page of your Use and Care Guide.
8212656RP
■
8212641RP
■
8212646RP
■
8212545RP
■
8212487RP
■
8212638RP
■
8212637RP
■
Alternate parts (Not supplied with washer):
Your installation may require additional parts. To order, please refer
to toll-free numbers on back page of your Use and Care Guide.
If you have:
Overhead sewer
1" (25 mm) standpipe
Drain hose too short
Lint clogged drain
Location Requirements
Select proper location for your washer to improve performance
and minimize noise and possible "washer walk". Install your
washer in a basement, laundry room, closet, or recessed area.
43
/
"
1
2
(1105 mm)
10 ft. (3.0 m) Inlet hose, Black EPDM
(2 pack)
5 ft. (1.5 m) Inlet hose, Black EPDM
(2 pack)
4 ft. (1.2 m) Inlet hose, Black EPDM
(2 pack)
5 ft. (1.5 m) Inlet hose, Red and Blue
EPDM (2 pack)
5 ft. (1.5 m) Nylon braided inlet hose
(2 pack)
6 ft. (1.8 m) Nylon braided inlet hose,
space-saving 90° elbow, hypro-blue
steel couplings (2 pack)
6 ft. (1.8 m) Inlet hose, Black EPDM,
space-saving 90° elbow, hypro-blue
steel couplings (2 pack)
You will need:
Standard 20 gal. (76 L) 39" (990 mm)
tall drain tub or utility sink, sump pump
and connectors (available from local
plumbing suppliers)
2" (51 mm) diameter to 1" (25 mm)
diameter Standpipe Adapter
Part Number 3363920 Connector Kit
Part Number 285835
Extension Drain Hose Part Number
285863 Connector Kit
Part Number 285835
Drain Protector Part Number 367031
Connector Kit Part Number 285835
27
"
27
/
"
1
2
(686 mm)
(699 mm)