Table des Matières
Publicité
GENERAL INFORMATION
This equipment is destined for use by professionals. The user
should read this instruction manual and any other additional
information supplied by Varian before operating the equipment.
Varian will not be held responsible for any events occurring due
to non-compliance, even partial, with these instructions, im-
proper use by untrained persons, non-authorized interference
with the equipment or any action contrary to that provided for by
specific national standards.
The Turbo-V 2K-G is an integrated system with a turbo-
molecular pump for high and ultra-high vacuum applications
with its relevant controller. The system can pump many types of
gases or gas compound. It is not suitable for pumping liquids or
solid particles. The pumping action is obtained through a high
speed turbine (max. 33000 rpm) driven by a high-performance
3-phase electric motor. The Turbo-V 2K-G is free of
contaminating agents and, therefore, is suitable for applications
requiring a "clean" vacuum.
It is equipped with auxiliary connectors to be controlled from a
remote site by means of an host computer connected through a
serial line (RS232 or RS485).
The following paragraphs contain all the information necessary
to guarantee the safety of the operator when using the equip-
ment. Detailed information is supplied in the appendix "Techni-
cal Information".
This manual uses the following standard protocol:
WARNING!
The warning messages are for attracting the attention of the
operator to a particular procedure or practice which, if not fol-
lowed correctly, could lead to serious injury.
!
CAUTION
The caution messages are displayed before procedures which,
if not followed, could cause damage to the equipment.
NOTE
The notes contain important information taken from the text.
STORAGE
In order to guarantee the maximum level of performance and
reliability of Varian Turbomolecular pumps, the following guide-
lines must be followed:
•
when shipping, moving and storing pumps, the following
environmental specifications should not be exceeded:
•
temperature range: -20 YC to 70 YC
•
relative humidity range: 0 to 95% (non condensing)
•
the turbomolecular pumps must be always soft-started
when received and operated for the first time by the cus-
tomer
•
the shelf life of a turbomolecular pump is 10 months from
the shipping date.
!
CAUTION
If for any reason the shelf life time is exceeded, the pump has
to be returned to the factory. Please contact the local Varian
Vacuum Sales and Service representative for informations.
PREPARATION FOR INSTALLATION
The Turbo-V 2K-G is supplied in a special protective packing. If
this shows signs of damage which may have occurred during
transport, contact your local sales office.
When unpacking the system, be sure not to drop it and avoid
any kind of sudden impact or shock vibration to it. Cause its
weight (35 kg), use the three eyebolts screwed at 120Y on the
pump body to extract the pump from the package.
Do not dispose of the packing materials in an unauthorized
manner. The material is 100% recyclable and complies with
EEC Directive 85/399.
In order to prevent outgassing problems, do not use bare hands
to handle components which will be exposed to vacuum. Al-
ways use gloves or other appropriate protection.
Normal exposure to the environment cannot damage the Turbo-
V 2K-G. Nevertheless, it is advisable to keep it closed and
sealed until it is installed in the system. This will prevent the
system from contamination.
The Turbo-V 2K-G package includes:
17. pump with integrated controller
18. inlet screen (mounted)
19. this instruction manual on CD-ROM
20. accessories bag:
21. 15 pin mating connector IP 54 for "REMOTE I/O" connec-
tor with all the interconnections necessary to start the
pump.
22. 9 pin mating connector IP-54 for "SERIAL" connector to be
used for serial connection
23. 9 pin mating connector for "Network" MoniTorr
24. Retaining bracket to retain the power cable (mounted)
66
INSTRUCTIONS FOR USE
!
CAUTION
NOTE
87-900-968-01(C)
Publicité
Table des Matières
