Adjusting The Carrying Strap; Use; Starting When The Engine Is Cold - Parkside PBLG 52 A1 Traduction Du Mode D'emploi D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

Adjusting the carrying strap

WARNING!
The carrying strap 2 should always be worn during work.
Otherwise, the appliance cannot be controlled safely and may cause
injury to the user or others.
Make sure that you have secured and correctly adjusted the carrying
strap 2.
If the carrying strap 2 is open, there is a risk that it can get caught or
sucked into the blower of the machine.
Proper adjustment of the carrying strap 2 and appliance will make
working much easier. Adjust the carrying strap 2 to the optimum
working position.
Position the hip strap at hip level, not too far down the stomach. Tighten
the hip strap so you can feel the weight of the appliance resting on
your hips.
Tighten the two shoulder straps and adjust them until you achieve the
best working position.
PBLG 52 A1

Use

CAUTION!
Please comply with the statutory provisions in the relevant noise protec-
tion regulations.
Before starting the appliance, always check that:
The fuel system is not leaking.
All screw connections are firmly seated.

Starting when the engine is cold

ATTENTION!
Never allow the pull start z to whip back. This could cause damage.
Set the On/Off switch 0 to "I".
Press the throttle 9 halfway down and then push down the throttle
lock
.
Now release the throttle 9 and the throttle lock
The throttle 9 is now locked.
Pull the choke t out.
Press the fuel pump (primer) a 6x.
Press the appliance against the floor with your left hand on the
frame 1 (ATTENTION! Do not use your foot!). With your right hand
on the pull start z, pull it slowly until you feel resistance.
ATTENTION!
Always pull the pull start z straight out. Hold the handle of the pull
start z firmly when the pull start z retracts. Do not allow the pull
start z to whip back.
Now pull the pull start z quickly so that the engine starts.
If the engine does not start, repeat the process.
When the engine starts, press down the throttle 9. The choke will be
reset.
If the engine does not start after several attempts, read the "Trouble-
shooting" section.
NOTE
At high outdoor temperatures it is possible that even a cold engine has
to be started without using the choke t!
.
GB │ IE 
 7

Publicité

Table des Matières
loading

Table des Matières