Technical Data; Instructions For Use; Installation - SKF LAHD 500 Mode D'emploi

3

TECHNICAL DATA

Boundary dimensions
- LAHD 500
- LAHD 1000
Reservoir volume
- LAHD 500
- LAHD 1000
Container material
Temperature range permitted
Permissible humidity
Length of connecting tube
Connection thread
Tube material
O-ring material
Gaskets
Other material
Suitable oil types
4

INSTRUCTIONS FOR USE

4.1

Installation

1. Determine the required oil level in the application during operation.
For oil lubricated bearing housings this is normally defined as two millimetres
(0,08 in) above the inner diameter of the outer ring of the bearing.
It is however, strongly advised to check the recommendations from the
bearing manufacturer. Similar recommendations exist for gear boxes and
crank shaft casings.
2. Determine the best location for the installation of the support bracket
assembly. The oil leveller must not be more than 60 cm (2 feet, length of
plastic tube) from the application.
Bracket assembly
6
Ø 91 mm x 290 mm high (3,6 x 11,4 in)
Ø 122 mm x 290 mm high (4,8 x 11,4 in)
500 ml (17 fl. oz. US)
1000 ml (34 fl. oz. US)
Polycarbonate
- 20 .. 125 °C (-5 .. 255 °F)
0 - 100 %
600 mm (2 feet)
G 1/2
Polyurethane
NBR - 70 Shore
NBR - 80 Shore
6 pieces, 3 pcs 3 x 64,5 x 82,5 mm
2 pcs 2 x 64,5 x 82,5 mm
1 pcs 2 x 62,5 x 82,5 mm
Aluminum, Bronze, Stainless Steel
Mineral and synthetic oils
SKF LAHD 500-1000