Rear Panel - Fender PASSPORT VENUE Mode D'emploi

thermal trouble. The Passport will reset itself as soon as the problem
has been resolved. If the Passport will not reset and the Protect light
stays red even after you've tried different power outlets and given it
time to cool down, take it to an authorized Fender Service Center. If
neither LED illuminates when powered on, check the Fuse
Power Socket.
USB Record / Playback
VOLUME
TONE
The Passport Venue features an integrated USB playback/record system that allows you to
playback .wav and .mp3 files as well as record .wav audio files using a USB flash drive.
MASTER VOLUME OUTPUT L R TONE
USB USB
1 2 3 4
1 2 3 4
Use Channel 8 to control USB playback level and tone and use the Channel
VOLUME VOLUME VOLUME VOLUME
LEVEL LEVEL LEVEL LEVEL
8 Signal Indicator to monitor recording levels.
USB — Plug your USB flash drive in here.
TREBLE TREBLE TREBLE TREBLE
HIGH HIGH HIGH HIGH
RECORD — Press to record a new track, then press again
to stop recording. The button will illuminate during recording.
Tracks are recorded in stereo as 16 bit/44.1kHz .wav files. NOTE: USB
BASS BASS BASS BASS
LOW LOW LOW LOW
recording levels are determined by the Channel VOLUME
If your recording is too quiet, increase the levels on the channels
that are too soft, but be careful, if you hear distortion you have
increased the levels too much!
REVERB REVERB REVERB REVERB
REVERB REVERB REVERB REVERB
Tracks recorded to your USB flash drive will be saved with sequential filenames:
"Venue Track 1" then "Venue Track 2," etc. Each recorded track will always be named
PAD PAD PAD PAD
sequentially after the last track recorded, even if tracks earlier in the sequence have been PAD PAD PAD PAD
deleted. For example, if you delete "Venue Track 1" but not "Venue Track 2," the next
track recorded will be named "Venue Track 3." NOTE: If a recording exceeds 2GB in size
PHANTOM POWER
(approximately 3 hours of recording time) it will be divided into separate, sequentially
MIC MIC MIC MIC
PHANTOM POWER
named files; a small gap in the recording may be present between files.
INPUT INPUT INPUT INPUT
LINE LINE LINE LINE
PLAY / PAUSE — Press
drive. Press again to pause playback and the button will flash. Press
and hold for 2 seconds to stop completely (button turns off).
Pressing the next time will start playback from the first track
STEREO LEVEL
OUT LEVEL MONO
PHONES OUT
on the USB flash drive.
OUT
Tracks on your USB flash drive will play back in alphanumerical order, with the numbered
PROTECT
track titles playing first.
PREVIOUS — Press to jump to the beginning of the current
track, or within the first 3 seconds of the current track to skip to the
beginning of the previous track. Press and hold
for reverse scan.
NEXT — Press
to jump to the beginning of the next track.
Press and hold for 2 seconds to forward scan.
Erasing Tracks Recorded to Flash Drive:
To erase only the tracks you recorded to the USB flash drive but nothing else: Press and
hold + until starts to blink, then press
sequentially. To abort the operation before erasing has started, press any button other than
.
Formatting your Flash Drive:
To completely wipe all files from your USB flash drive: Press and hold
until & flash slowly. Then press
rapidly. Press again and formatting will begin. All four buttons will flash sequentially.
To abort the operation before formatting has started, press either
in the
REVERB
REVERB
SELECT TIME TONE
SELECT TIME TONE
REVERB 1
REVERB 2
5 6 7 8/USB
5 6 7/8 9/10
VOLUME VOLUME VOLUME VOLUME
LEVEL LEVEL LEVEL LEVEL
TREBLE TREBLE TREBLE TREBLE
HIGH HIGH HIGH HIGH
BASS BASS BASS BASS
LOW LOW LOW LOW
knobs.
REVERB REVERB REVERB REVERB
REVERB REVERB REVERB REVERB
STEREO STEREO
LINE LINE INPUT INPUT
PAD PAD
STEREO STEREO
L/MONO L/MONO
INPUT INPUT
MIC MIC
L / MONO L / MONO
RIGHT RIGHT
INPUT INPUT INPUT INPUT
LINE LINE RIGHT RIGHT
to play the tracks on your USB flash
PRE OUT/POWER AMP IN SUB OUT
SUB
OUT
LEFT RIGHT
POWER
POWER PROTECT
for 2 seconds
. All four buttons will flash
+
once and & will flash
or .
100 -120V ~ 220 - 240V ~
50/60Hz 50/60Hz
This product
is covered by
US patent No.
ON OFF
5,933,507
CAUTION:
FUSE
T10A H TO REDUCE THE RISK OF
FIRE, REPLACE FUSE WITH
250V
SAME TYPE AND RATING
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME
TYPE ET CALIBRE
INPUT POWER
750W
VOLTAGE SELECTOR — Change this setting only if you travel to a
country that requires a different voltage setting.
POWER — Switches the Passport on-off.
POWER SOCKET — Connect to a grounded AC outlet in accordance
with the proper Voltage Selector
FUSE — To replace a failed fuse, unplug the power cord, then pry
the fuse holder out of the Power Socket
same type and rating.
SPEAKER OUTPUTS — Connect the Passport speakers here using
the cables provided.
TYPE: PR 846
PART NUMBERS:
6947000000 (120V~, 60Hz)
6947001900 (110V~, 60Hz) TW DS
6947004900 (230V~, 50Hz) UK
6947006900 (230V~, 50Hz) EU DS
6947008900 (220V~, 50/60Hz) CN DS
6947013900 (240V~, 50Hz) MA DS
POWER REQUIREMENT: 750W
FUSE:
T10A H, 250V
DIMENSIONS: Height: 23 in (58.4 cm)
Depth: 11 in (27.9 cm)
WEIGHT:
44 lb (20 kg)
Product specifications are subject to change without notice.
USB Specifications and Formats
USB file format: FAT16, FAT32
MP3 bit rate: 8k-320Kbps, sample rate: 8K-48kHz, VBR is supported
WAV (PCM) Playback:
8/16bit, sample rate <=48kHz
+
WAV (PCM) Recording:
16bit, 44.1K sample rate, stereo
For more detailed USB information, log on to fender.com and visit the Support area.

Rear Panel

Laite on liitett ¨ av ¨ a suojamaadoituskoskettimilla TYPE: PR 846
va rustettuunpistorasiaan
Apparatet må tilkoples jordet stikkontakt
Apparaten skall anslutas till jordat uttag
SERIAL NUMBER
Use only with supplied
4 ohm speakers
SPEAKER OUTPUTS
600W total
4Ω MIN 300W
C
A PRODUCT OF: 158744
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA U.S.A.
MADE IN CHINA
setting.
. Only use a fuse of the
Specifications
6947000900 (120V~, 60Hz) DS
6947003900 (240V~, 50Hz) AU DS
6947005900 (220V~, 50Hz) ARG DS
6947007900 (100V~, 50/60Hz) JP DS
6947009900 (220V~, 60Hz) ROK DS
Width: 29 in (73.6 cm)
THIS DEVICE COMPLIES WITH
PA RT 15 OF FCC R U L E S .
OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
WARNING:
FENDER AMPLIFIER SYSTEMS
ARE CAPABLE OF PRODUCING
VERY HIGH SOUND PRESSURE
LEFT
LEVELS WHICH MAY CAUSE
TEMPORARY OR PERMANENT
HEARING DAMAGE. USE CARE
WHEN SET TING AND ADJUSTING
VOLUME LEVELS DURING USE.
RIGHT
CAUTION:
CHASSIS SURFACE HOT
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
E X P O S E T H I S E Q U I P M E N T T O
RAIN OR MOISTURE
AVIS:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATTENTION:
SUPERFICIE DE CHASSIS CHAUDE
US
11