System Setup - Fender PASSPORT VENUE Mode D'emploi

Congratulations on your purchase of the Fender® Passport®
Venue audio system. Your Passport is a self-contained,
Portable audio system that includes everything you need
for great sound anywhere you go! Carry your Passport as
you would a suitcase. When you arrive, simply flip open the
cabinet release latches and inside you'll discover two full-
range speaker cabinets, a powered mixer, plus all the cables
you'll need to get started.
Use your Passport as a public address system or to amplify
musical instruments and singing. Connect a mobile device
for music playback or play audio files directly from a USB flash
drive. To capture a stereo mix of your performance simply
connect a USB flash drive and hit "record".
The Passport's quick and easy set-up, its ability to cover large
audiences and its simple operation are the hallmarks of this
1. Flip open the cabinet latches on top of the Passport
and detach the speaker cabinets from the powered
mixer section.
2. For optimal results, elevate the speaker cabinets on
Passport Speaker Stands or on sturdy tables and
place the speakers far apart to maximize stereo
separation. Position the mixer close to where you
will be performing so you will have easy access to
the control panel.
8
innovative product. The Passport's control panel features
both mono mic/line channels and stereo line channels with a
variety of input jacks to provide you with superb flexibility in
making connections.
Don't forget to visit
line of Passport accessories and more!
Please visit the individual product page at:
series/passport
how to get your amplifier serviced under warranty in U.S.A.
and Canada; see your Fender distributor for warranty details
in other countries.
PRODUCT REGISTRATION — Please visit:
System Set-Up
3. Open the storage
compartment
the rear
mixer and remove
the power cord and
speaker cables.
4. Plug the speaker cables into the left and right
speaker jacks on the back of the mixer, then
connect the corresponding left and right speakers.
Make sure the power switch is off, then plug the
supplied power cord into the power socket on
the back of the mixer and the other end into a
grounded AC power outlet.
www.fender.com/passport
for full warranty details and instructions on
www.fender.com/product-registration
on
of the
Laite on liitett ¨ av ¨ a suojamaadoituskoskettimilla TYPE: PR 846
va rustettuunpistorasiaan
Apparatet må tilkoples jordet stikkontakt
Apparaten skall anslutas till jordat uttag
SERIAL NUMBER
THIS DEVICE COMPLIES WITH
PA RT 15 OF
OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT
Use only with supplied
ANY INTERFERENCE RECEIVED,
4 ohm speakers INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
SPEAKER OUTPUTS
WARNING:
FENDER AMPLIFIER SYSTEMS
ARE CAPABLE OF PRODUCING
VERY HIGH SOUND PRESSURE
LEFT
LEVELS WHICH MAY CAUSE
TEMPORARY OR PERMANENT
HEARING DAMAGE. USE CARE
100 -120V ~ 220 - 240V ~ WHEN SET TING AND ADJUSTING
600W total
50/60Hz 50/60Hz VOLUME LEVELS DURING USE.
4Ω MIN 300W
RIGHT
This product
CAUTION:
is covered by
CHASSIS SURFACE HOT
ON OFF US patent No.
WARNING:
5,933,507
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
E X P O S E T H I S E Q U I P M E N T T O
RAIN OR MOISTURE
CAUTION:
FUSE AVIS:
T10A H TO REDUCE THE RISK OF
RISQUE DE CHOC ELECTRIQUE
FIRE, REPLACE FUSE WITH
250V NE PAS OUVRIR
SAME TYPE AND RATING
ATTENTION:
SUPERFICIE DE CHASSIS CHAUDE
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME C US
TYPE ET CALIBRE
A PRODUCT OF: 158744
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA U.S.A.
INPUT POWER
MADE IN CHINA
750W
to see a full
www.fender.com/
FCC R U L E S .