Prepare The Receiver Collar; To Insert And Remove The Receiver Collar Battery; To Set The Static Correction Level - Petsafe Stay! Mat The Wireless Crate Guide D'emploi Et De Dressage

Prepare the Receiver Collar

Step
2
Your Receiver Collar comes with short Contact Points installed. Use the long Contact
Points for pets with long or thick hair. Tighten the Contact Points with the Contact
Point Wrench portion of the Test Light Tool (2A) one-half turn beyond finger tight
(2B). Check the tightness weekly.

To Insert and Remove the Receiver Collar Battery

Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
is designed to make battery replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver Collar
(triangle) (2C). Use the Battery Wrench portion of the Test Light Tool (2A) to turn the
battery clockwise until the arrow lines up with the lock symbol on the housing.
To remove the battery, turn the battery counter-clockwise using the Battery Wrench
portion of the Test Light Tool (2D). DO NOT attempt to cut into or pry open the
battery. Be sure to discard the used battery properly.
A replacement PetSafe
Customer Care Center at 1-800-732-2677 (US), 1-800-457-3911 (Canada) or visit
our web site at www.petsafe.net to locate a retailer near you.

To Set the Static Correction Level

Read all steps before attempting to set the
Static Correction Level.
1. Remove the clear plastic cover with the Battery
Wrench portion of the Test Light Tool (2A) to
expose the Correction Level Button (2E).
2. With the battery installed, press the
Correction Level Button and release when
the Receiver LED Indicator Light lights up
(2F).
3. The Receiver LED Indicator Light will
emit a series of fl ashes representing the
Static Correction Level.
4. Increase the Static Correction Level by
pressing and releasing the Correction Level
Button within 5 seconds of the previous
series of fl ashes.
5. After setting the Static Correction Level,
replace the cover to protect the Correction Level Button.
The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the
Receiver Collar is on will cause the Receiver Collar to revert to level 1. Refer to the Function and Response Table to
choose the Static Correction level that best fi ts your pet.
The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains
in the Static Correction Zone if the collar is set at level 2 or above.
The Receiver LED Indicator Light acts as a low battery indicator, fl ashing every 4 to 5 seconds when replacement
is required.
6
®
battery (RFA-67) can be found at many retailers. Contact the
2E
1-800-732-2677 (US) / 1-800-457-3911 (Canada
®
battery (RFA-67). This unique battery
2A
Contact Point Wrench
Test
Light
Test Light
Contacts
2B
2C
2D
2F
)
Battery
Wrench