Function And Response Table; Prepare The Stay! Mat; Test The Stay! Mat - Petsafe Stay! Mat The Wireless Crate Guide D'emploi Et De Dressage

Function and Response Table

Indicator Light
Response
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
Flashes once every
4 to 5 seconds
Note: Begin training Correction Level 1 (Beep Only).
____________________________________________________________________________________________________

Prepare the Stay! Mat

Step
3
To Install the Batteries
1. Make sure the switch is in the "OFF" position.
2. Remove the fabric covering from the Stay! Mat
3. Open the battery door and install 4 AA batteries (not included).
4. Replace the battery door and fabric cover.
5. Do not over tighten the cover or the Stay! Mat
____________________________________________________________________________________________________

Test the Stay! Mat

Step
4
To Test the Beep Only Mode
1. Set the Switch on the Stay! Mat
2. Place your hand on the Stay! Mat
Press moderately on the mat for approximately 8 seconds to simulate the presence
of the dog. Note: The Stay! Mat
presence of the Receiver Collar.
3. Remove your hand from the mat. The Receiver Collar should beep once your hand is
removed from the Stay! Mat
™
Stay! Mat
4. Move the collar away from the mat to test the range of the system. This will help you
gauge the size of the Static Correction Zone (4B).
5. Return to the Stay! Mat
the mat again with your hand. The Receiver Collar should stop beeping and the green
light on the mat should start blinking.
6. The test is now complete. Turn the Stay! Mat
Note: It will be necessary to turn the mat off each time you place your dog on the Stay! Mat
call him off the Stay! Mat
correction for exiting or entering the Stay! Mat
step is not followed, your dog will be confused and training will be diffi cult.
To Test the Beep and Static Correction Mode
Set the Static Correction Level to level 2. Test the Static Correction Mode on the
Receiver Collar the same way as testing the Beep Only Mode while holding the Test Light
Tool to the Contact Points (4C). When the Receiver Collar is correcting, it should beep
and the Test Light should fl ash.
Static
Correction Level
1
2
3
4
5
™
to Beep Only.
™
and hold the Receiver Collar over the mat (4A).
™ detects the presence of the dog by his weight, not by the
™
. This is the beep reminding the dog to return to the
.
™
, hold the Receiver Collar over the mat, and apply pressure to
™ . If you do not turn the mat off, your dog will receive a beep or static
Receiver Collar Function
No Static Correction, Beep Only
Low Static Correction
Medium Static Correction
Medium High Static Correction
High Static Correction
Low Battery
™
™
.
™
will not operate properly.
™
™ switch to the "OFF" position.
™
. If this training
www.petsafe.net
Temperament of Pet
Timid
Timid or Average
Average or High Energy
High Energy
4A
4B
™ or
4C
7