Installing Linking Sections; Search Loops For Offset Drive Home - Viking MI 632 Manuel D'utilisation

Installing a corridor:
Wire clearance in corridors: 27 cm
(distance C on the iRuler).
This results in the following space
requirements:
– between high obstacles (> 2 cm –
e.g. walls):
108 cm,
– between paths/obstacles that can be
travelled on (≤ 2 cm – e.g. paths):
27 cm.
134
In corridors, the perimeter wire (1) must be
routed parallel and attached to the ground
with a sufficient number of fixing pins (2).
At the start and end of the corridor, funnel-
shaped entrance and exit areas must be
installed.

12.10 Installing linking sections

The robotic mower ignores the perimeter
wire signal if the wires are routed parallel
and close together. Linking sections must
be installed:
– where secondary areas are to be
installed. ( 12.8)
– where no-go areas are necessary.
( 12.7)
VIKING recommends laying linking
sections together with the relevant
no-go areas or secondary areas
during wire routing.
In the case of retrospective
installation, the wire loop must be
cut and linking sections must then
be integrated using the wire
connectors supplied. (
In linking sections, the perimeter wire (1)
must be routed parallel, the wires must not
cross and must be close to one another.
Attach the linking section to the ground
with a sufficient number of fixing pins (2).
12.11 Search loops for offset drive
home
If offset drive home is activated, search
loops must be provided
– if an external docking station has been
installed
or
0478 131 9933 A - EN
12.15)