Sharpening The Mowing Blade; Removing And Installing The Carrier Plate - Viking MI 632 Manuel D'utilisation

Fit the mowing blade (1) on the carrier
plate (2) as illustrated. Ensure the correct
position of the retainers (3) in the mowing
blade.
Screw on the fastening nut (1) as far as
possible. Several clicks are audible during
tightening. Ensure secure seating of the
mowing blade by shaking carefully.
0478 131 9933 A - EN
● Following installation of a new mowing
blade, confirm the blade replacement in
the "Service" menu. ( 11.17)

16.5 Sharpening the mowing blade

Never re-sharpen blades.
VIKING recommends always replacing a
blunt blade with a new one.
Only new mowing blades are
balanced with the necessary
precision and guarantee proper
functioning of the machine as well
as low noise emissions.
16.6 Removing and installing the
carrier plate
The carrier plate can be removed in
order to clean the mowing deck.
● Activate the disabling
device ( 5.2) and wear
gloves.
● Tilt the robotic mower onto its
side and lean it securely against a
stable wall. Carefully clean the mowing
deck and mowing blade. (
Removing the carrier plate:
● Remove the mowing blade. (
Insert puller (I) into the carrier plate as
shown and turn anti-clockwise to the stop.
16.2)
Support the machine with one hand.
16.4)
Remove the carrier plate (1) by pulling on
the puller (I).
145