Bbpr Models; Led Meaning - VALPES ER PLUS Manuel D'installation Et D'utilisation

EN
BBPR model
Following a power failure, the BBPR unit will reset after 3 minutes.
Actuator with BBPR integrated backup system (ON/OFF mode compulsory)
BBPR model integrate a battery pack monitored by an electronic board inside the actuator. Its function is to relay in case of power
supply failure on terminal PIN 1,2 and 3 of the actuator. The BBPR system can be set on different position like normally open (NO) or
normally closed (NC). It depends on customer application.
The electronic board monitors the battery pack and check the status of battery (cycle load and failure)
If a battery failure is detected , a contact on PIN 65 and 66 switch off. If customer use this contact he could be aware that there is a
failure on battery in the actuator without remove cover and plan the replacement.
Fail safe option required ON/OFF mode.
The factory default configuration is "normally closed"
Loading electronic board
Voltage
Nominal current
Courant maximal
Initial loading time
Load state feedback relay
Temperature

LED meaning

LED
DSBA3200 • Rév. 09/06/2020
D
B
C
18V DC
0,8A
2,4A
14h max
24V DC - 1A max
-10°C to 40°C
Green LED Red LED
Off Blinks/off/Blinks... Battery disconnected or out of service
On Blinks
On Off
Blinks rapidly Off
Off Blinks rapidly
E
REP DESIGNATION
A 18V DC terminal strip
B Block battery terminal strip
C State feedback terminal strip (load or battery failure)
D Green LED
E Red LED
Battery loading cycle in progress (max 14h)
Battery loading cycle finished
Actuator electrical supply during 3 minutes (failure mode)
Microcontroller failure
A
23