Assembly; Fit The Wheel Kit; Secure The Stand - Husqvarna DMS 240 Manuel D'utilisation

Fit the wheel kit

Fit the wheel kit on the mount on the rear side of the bottom
plate and tighten the screws.

Secure the stand

There are three methods for fixing the stand.
• Securing with vacuum plate
• Fixing with expander or anchor
• Fixing with threaded rod, washer and lock nut
Securing with vacuum plate
WARNING! The vacuum plate must never be
!
used for ceiling or wall drilling. Careless or
incorrect use can result in serious, even
fatal injury.
If the vacuum plate is used, make sure the
support surface is not porous and can
loosen. Make sure that the vacuum pump
has sufficient power to secure the vacuum
plate.
• Connect the vacuum pump to the quick coupling for
vacuum pressure on the base plate.
• Place the bottom plate in the desired position.
• Switch on the vacuum pump. A minimum pressure of 635
mm Hg (25 inch Hg) must be reached so that the base
plate seals tightly against the surface.

ASSEMBLY

Fixing with expander or anchor
IMPORTANT! When drilling ceilings, only expander or
anchor suitable for surfaces exposed to tensile forces
should be used.
Use only expander or anchor which is approved for current
application.
• Drill a hole for the expander/anchor at a distance of 335
mm (13.2") from the centre of the hole.
• Bolt down the base plate.
Check carefully that the expander is secured correctly.
• The bottom plate can be adjusted to the surface by using
the leveling adjustment screws. Use the feed handle.
Fixing with threaded rod, washer and lock
nut
If the mounting surface is inadequate for drilling in roofs or
walls, the base plate can be fixed using a threaded rod, which
is mounted on the backside with a washer and lock nut.
Drilling in the ceiling
!
335 mm
(13,2")
WARNING! Use a water collector to avoid
water penetrating into the machine. The
machine must be covered with plastic or the
like in order to prevent water penetrating
into the machine, but do not cover the air
intakes and air outlets.
– 11
English