Parts And Controls; Basic Operation - Pioneer DMH-130BT Mode D'emploi

Parts and controls

Main unit
Press to turn off the display information. To turn on the display information,
press again.
Press and hold to power off. To power back on, press again.
TIP
If you power the unit off, you can turn off almost all functions. The unit turns
on by operating the following functions:
• A rear view camera image is input when the vehicle is in reverse.
• The ignition switch is turned off (ACC OFF), then turned on (ACC ON).
Press to display the top menu screen.
Press and hold to mute or unmute.
-
VOL (+/ )
RESET Press to reset the microprocessor (page 5).
LCD screen
Remote control
The remote control is sold separately. For details concerning operations, see the remote
control manual.

Basic operation

Resetting the microprocessor
CAUTION
• Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
• The microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
1
Turn the ignition switch OFF.
2
Press RESET with a pen tip or other pointed tools.
Settings and recorded contents are reset to the factory settings.
Using the touch panel
You can operate this product by touching the keys on the screen directly with your
fingers.
NOTE
To protect the LCD screen from damage, be sure to touch the screen only with your finger gently.
Common touch panel keys
: Returns to the previous screen.
: Close the screen.
5
En