Weblink - Pioneer DMH-130BT Mode D'emploi

WebLink™

You can operate WebLink compatible applications with finger gestures such as tapping,
dragging, scrolling, or flicking on the screen of this product.
NOTES
• The supported finger gestures may vary depending on the WebLink compatible application.
• To use WebLink, you must first install the WebLink Host app on the iPhone or smartphone. For details
about the WebLink Host app, visit the following site: https://www.abaltatech.com/weblink/
• Be sure to read Using app-based connected content (page 20) before you perform this operation.
• Copyright protected files such as DRM cannot be played.
WARNING
Certain uses of the iPhone or smartphone may not be legal while driving in your jurisdiction, so you
must be aware of and obey any such restrictions. If in doubt as to a particular function, only perform it
while the car is parked. No feature should be used unless it is safe to do so under the driving conditions
you are experiencing.
Using WebLink
Important
• Pioneer is not responsible for content or functions accessed via WebLink, which are the responsibility
of the application and content providers.
• Availability of non-Pioneer content and services, including apps and connectivity, may change or
discontinue without notice.
• When using WebLink with the Pioneer product, available content and functions will be limited while
driving.
• WebLink allows access to applications other than those listed, subject to limitations while driving.
Starting procedure
For iPhone users
System requirement
iOS 13.4 or higher
NOTE
[iPhone Connected Launch] is set to [WebLink] (page 15).
1
Unlock your iPhone and connect it to this product via USB.
WebLink is automatically launched.
TIP
You can also start this source by pressing
NOTE
For USB connection, refer to the Installation Manual.
For smartphone (Android™) users
System requirement
Android 7.0 or higher
NOTE
The video playback capability depends on the connected Android device.
1
Unlock your smartphone and connect it to this product via USB.
WebLink is automatically launched.
TIP
You can also start this source by pressing
NOTES
• For USB connection, refer to the Installation Manual.
• Make sure that file transfer mode for USB connection is enabled on your smartphone if WebLink
does not start automatically.
Basic operation
Touch the desired application icon after the WebLink app is launched. The desired
application is launched, and the application operation screen appears.
Displays the main menu of the WebLink source screen.
TIPS
• If you connect your device to this product while a WebLink compatible application is already running,
the application operation screen will appear on this product.
• Check the Bluetooth connection between the mobile device and this unit if there is no sound output
from this unit (page 7).
then touching [WebLink].
then touching [WebLink].
13
En