Zanussi ZBF22451SA Notice D'utilisation page 19

Problem
A rectangular symbol is shown
instead of numbers on the
Temperature Display.
The compressor operates con-
tinually.
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the display.
The temperature in the appli-
ance is too low/too high.
Possible cause
Temperature sensor prob-
lem.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The QuickFreeze is switched
on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The QuickFreeze or Quick-
Chill function is switched on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
Solution
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible).
Refer to "Operation".
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze function".
Refer to "Closing the door".
The compressor starts after a pe-
riod of time.
Attach the melting water outlet to
the evaporative tray.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to
set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
Keep the OK pressed for approx-
imately 10 seconds until a long
sound is heard and display shuts
off for a short time.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
19