Zanussi ZBF22451SA Notice D'utilisation page 15

DISPLAY
A
SWITCHING ON
1. Connect the mains plug to the power socket.
2. Press the appliance ON/OFF if the display is
off.
The alarm buzzer could operate after few seconds.
The temperature indicators show the set default
temperature.
To reset the alarm refer to "High temperature
alarm".
To select a different set temperature refer to
"Temperature regulation".
If "dEMo" appears on the display, refer to
"Troubleshooting" chapter.
SWITCHING OFF
1. Press the appliance ON/OFF for 5 seconds.
The display switches off.
2. Disconnect the mains plug from the power
socket.
TEMPERATURE REGULATION
Set the temperature of the appliance by pressing
the temperature regulators.
Default set temperature:
• -18°C for the freezer
The temperature indicators show the set
temperature.
The set temperature will be reached
within 24 hours.
After a power failure the set
temperature remains stored.
HIGH TEMPERATURE ALARM
An increase in the temperature in the freezer
compartment (for example due to an earlier power
failure) is indicated by flashing the alarm icon and
freezer temperature indicators, and sounding of
buzzer.
Press any button.
The buzzer switches off.
The freezer temperature indicator shows the
highest temperature reached for a few seconds,
then displays the set temperature again.
B C
F E D
A. Timer indicator
B. QuickFreeze function
C. Temperature indicator
D. Alarm indicator
E. ChildLock function
F. DrinksChill function
The alarm indicator continues to flash
until the normal conditions are
restored.
QUICKFREEZE FUNCTION
The QuickFreeze function accelerates the freezing
of fresh food and, at the same time, protects
foodstuffs already stored from undesirable
warming.
1. To activate this function press the Mode button
until the corresponding icon appears.
The QuickFreeze indicator flashes.
2. Press the OK button to confirm.
TheQuickFreeze indicator is shown.
This function stops automatically after 52 hours.
To switch off the function before its automatic end
repeat the procedure until the QuickFreeze
indicator turns off.
The function switches off by selecting
a different set temperature.
DOOR OPEN ALARM
An acoustic alarm will sound if the door is left open
for a few minutes. The door open alarm conditions
are indicated by:
• a flashing Alarm indicator;
• an acoustic buzzer.
When normal conditions are restored (door
closed), the alarm will stop. The buzzer can also be
switched off by pressing any button.
CHILDLOCK FUNCTION
Activate the ChildLock function to lock the buttons
from unintentional operation.
1. Press Mode until the corresponding icon
appears.
The ChildLock indicator flashes.
2. Press OK to confirm.
The ChildLock indicator is shown.
To deactivate the ChildLock function, repeat the
procedure until the ChildLock indicator goes off.
15