Servicing And Cleaning; Function Test; Cleaning; Disposal - Abus eyseo TVCC50010 Manuel Utilisateur

DIGITAL OUT
COMM ID
PRIORITY (not
selectable)
DEFAULTS

9. Servicing and cleaning

9.1 Function test

Check the technical safety of the product such as damage to the housing at regular intervals.
When it can be assumed that the safe operation is no longer possible, the product must be put out
of service and precautions taken o ensure that it is not used unintentionally.
It must be assumed that safe operation is not longer possible if
•
the device shows visible signs of damage
• the device no longer operates and
•
has been stored for longer periods under unfavorable conditions or
•
has been subjected to considerable stress in transit.
Please note:
The product is absolutely maintenance-free for you. There are no components on the
inside of the product to be checked or services by you, never open it.

9.2 Cleaning

Clean the product with a clean, soft cloth. To remove severe contamination, the cloth can be
dampened with luke-warm water.
Make sure that no liquids can enter the equipment as the device can be destroyed.
Never use chemical detergents as they could attack the surface of the device.
10.

Disposal

Products which are labeled with this pictogram may not be disposed by the
domestic rubbish. Please dispose the product in accordance with the prevailing
legal regulations at the end of its life time.
Not available for TVCC50010/TV50510
Not available for TVCC50010/TV50510
ALC PRIORITY: VR / OSD
OSD: The ALC function is controlled by the settings in the OSD
menu.
VR: The ALC function is controlled by an external connector.
Only for board cameras, not TVCC50010/TVCC50510 –
JP10 has to be used (resistor, 500kΩ)
SWITCH PRIORITY: SWITCH / OSD
OSD: The settings of the camera a controlled by the OSD.
SWITCH: Part of the settings can be controlled by external switches.
Only for board cameras – JP1 has to be used.
Here you can restore the default setting.
RESTORE MODE: NO / YES -> EXECUTE
In order to restore the default setting, first confirm „YES" and then
„EXECUTE" by pressing the ENTER button.
30