Battery Charge Status - LD Systems LDMEI1000G2 Manuel D'utilisation

SYSTEM SETUp:
6
7
8
12
6
LIMITER
Press the SET button repeatedly until "LIMITER" appears in
the display and flashes. Using the
(Limiter ON) or disable (limiter OFF) the limiter.
7
LOCkING THE RECEIVER
Press the SET button repeatedly until the lock symbol appears in
the display. Press the
receiver. If the receiver is locked, the settings can be viewed, but
not changed.
8

BATTERY CHARGE STATUS

The charge status of the batteries is shown in four stages. In
addition to the fourth stage (no bars on the battery symbol) the
red LOW BATT LED will light up next to the display. The batteries
should now be replaced immediately.
button, you can enable
button to lock (ON) or release (OFF) the