Battery Replacement - LD Systems LD WSECO2 Manuel D'utilisation

BATTERY REPLACEMENT

7
As soon as the red LED lights up to indicate the
battery status, please replace the batteries by pres-
sing down on the battery compartment cover at the
marked position (OPEN) and slide it to the side.
Insert two 1.5 V AA size alkaline batteries (LR6, AA)
as in the illustration on the transmitter back and
close the battery compartment cover by pressing the
marked position (CLOSE) of the cover and then slide
it to the side.
If the transmitter is not in use for a long period of time,
remove the batteries from the battery compartment.
CHARGE
8
Low voltage socket for 3.5 mm barrel connector for
charging size AA batteries ( + inside, - outside).
- Use only a charger suitable for the batteries used and
be aware of the maximum permissible charging time.
- Please note that batteries inserted in the battery
compartment are switched in series!
- Never try to charge non-rechargeable batteries
Failure to comply with above instructions may result
in a fire or explosion hazard!
POCKET TRANSMITTER:
13