Machine Specific Safety Warnings For Polishers - Batavia MAXX Série Mode D'emploi

English
Service
2.5
a. Please use a qualified expert who
uses original replacement parts to
repair your power tool. This will ensure
proper functioning of the power tool.
3. Machine specific safety warn-
ings for polishers
a. This power tool is intended to function
as a polisher. Read all safety warnings,
instructions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire
and/or serious injury.
b. Operations such as grinding, sanding,
wire brushing or cutting-off are not
recommended to be performed with
this power tool. Operations for which
the power tool was not designed may
create a hazard and cause personal
injury.
c. Do not use accessories which are not
specifically designed and recom-
mended by the tool manufacturer. Just
because the accessory can be attached
to your power tool, it does not assure
safe operation.
d. The rated speed of the accessory must
be at least equal to the maximum
speed marked on the power tool.
Accessories running faster than their
rated speed can break and fly apart.
e. The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
f. Threaded mounting of accessories
must match the polisher spindle thread.
For accessories mounted by flanges,
the arbour hole of the accessory must
fit the locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool
will run out of balance, vibrate exces-
sively and may cause loss of control.
g. Do not use a damaged accessory.
Before each use inspect the accessory
for cracks, tear or excess wear. If power
6
7062891-Eccentric_Polisher-600W-Ma-1803-13.indb 6
tool or accessory is dropped, inspect
for damage or install an undamaged
accessory. After inspecting and install-
ing an accessory, position yourself and
bystanders away from the plane of the
rotating accessory and run the power
tool at maximum no-load speed for one
minute. Damaged accessories will nor-
mally break apart during this test time.
h. Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hear-
ing protectors, gloves and workshop
apron capable of stopping small abra-
sive or workpiece fragments. The eye
protection must be capable of stopping
flying debris generated by various oper-
ations. The dust mask or respirator
must be capable of filtrating particles
generated by your operation. Prolonged
exposure to high intensity noise may
cause hearing loss.
i. Keep bystanders a safe distance away
from work area. Anyone entering the
work area must wear personal protec-
tive equipment. Fragments of work-
piece or of a broken accessory may fly
away and cause injury beyond immedi-
ate area of operation.
j. Position the cord clear of the spinning
accessory. If you lose control, the cord
may be cut or snagged and your hand
or arm may be pulled into the spinning
accessory.
k. Never lay the power tool down until the
accessory has come to a complete
stop. The spinning accessory may grab
the surface and pull the power tool out
of your control.
l. Do not run the power tool while carrying
it at your side. Accidental contact with
the spinning accessory could snag your
clothing, pulling the accessory into your
body.
m. Regularly clean the power tool's air
vents. The motor's fan will draw the
dust inside the housing and excessive
accumulation of powdered metal may
cause electrical hazards.
22-03-18 11:13