Troubleshooting - USRobotics ADSL2+ Guide D'installation Rapide

English

Troubleshooting

I cannot connect to the router's Web User Interface.
Solution 1:
Make sure that all the Ethernet cables are properly and securely con-
nected and the power cord is plugged in.
Solution 2:
Make sure that your computer is using an IP address that is within the
default range of 192.168.2.xxx. Make sure the address of the subnet
mask is 255.255.255.0. The Default Gateway should be the IP address
of the Wireless ADSL2+ Router, which is 192.168.2.1.
Windows Me, 98, or 95 Users:
Click Windows Start > Run.
1.
2. Type winipcfg and click OK.
3. Check the IP Address, Subnet Mask, Default Gateway, and
DNS server data to make sure they are correct.
If the information is not correct, click Release All and then
click Renew All.
Windows XP, 2000, or NT Users:
Click Windows Start > Run.
1.
2. Type cmd and click OK.
3. At the DOS prompt, type ipconfig /all.
4. Check the IP Address, Subnet Mask, Default Gateway, and
DNS server data to make sure they are correct.
If the information is not correct:
A. Type ipconfig /release and press ENTER.
B. Type ipconfig /renew and press ENTER.
8