Troubleshooting - USRobotics USR5463 Guide D'installation Rapide

C. Your system will prompt you to save or open the file. Select Save.
D. Browse to the location at which you want the backup file saved and
click Save.
Connecting a Wireless Device
For your wireless device to connect to the Wireless Router, the wireless
adapter in the device must have settings that match those of the router.
1. Ensure that each wireless adapter that will be connected to the network
is set to infrastructure mode.
2. Set the SSID in the wireless adapter's settings to the SSID that is used
in the router. The router uses USR as its default SSID.
3. If you set wireless security on the router, ensure that the security set-
tings for the wireless adapter match those that you set on the Wireless
Router.
For instruction in changing your adapter's wireless mode, see your wireless
adapter's documentation. If you purchased the USR5475 Wireless Starter
Kit, see "Configuration" in the

Troubleshooting

I can't connect to the router's Web User Interface.
Solution 1:
Make sure all the Ethernet cables are properly and securely connected and
the power cord is plugged in.
Solution 2:
If your computer is configured to use a static IP address, you must now
reconfigure it to Obtain an IP address automatically.
Solution 3:
Make sure that your computer is using an IP address that is within the
default range of 192.168.2.xxx. Make sure the address of the subnet mask is
255.255.255.0. If necessary, the Default Gateway should be 192.168.2.1. To
verify all these settings, perform the following steps:
Windows Me, 98, and 95 Users:
Click Windows Start > Run.
1.
2. Type winipcfg and click OK.
3. Check the IP Address, Subnet Mask, Default Gateway, and DNS
server data to make sure they are correct.
If the information is not correct, click Release All > Renew All.
USR5423 USB Adapter User Guide
English
.
5