The Controls Of Your Beverage Center - Danby DBC128BLS Guide D'utiliser Et Soins De Propriètaire

1) Tempered Glass Door: Tinted for UV protection while
still allowing for easy interior viewing.
2) Magnetic Door Gasket: Tight fitting door seal keeps all
the cool air locked inside.
3) Plastic Coated Wire Shelves
4) Leveling Leg
5) Child Proof Lock with Key
6) Interior Light (not shown): Illuminates the compartment
when the door is opened.
THE CONTROLS OF YOUR
BEVERAGE CENTER
To start the Beverage Center, turn the temperature
control to the position corresponding to the desired
cooling. The Beverage Center temperature will vary
depending on the quantity of cans stored and on the
frequency with which the door is opened.
Setting The Temperature Control:
The temperature of the Beverage Center compartment
is controlled by adjusting/setting the thermostat
control knob, located on the exterior rear wall of the
cabinet.
To start the Beverage Center and achieve maximum
cooling quickly;
• Turn the temperature control knob clockwise to the
furthest (maximum) setting on the darker blue (wide)
section of the graduated control dial.
FEATURES
OPERATING INSTRUCTIONS
Fig. A
3
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the
temperature control knob setting to the 2 o'clock
position on the graduated blue control dial. See Fig.
A.
• To turn off the beverage center, (no cooling) rotate
the control knob to the "0" (off) position. See Fig. B
Turn the control to the "OFF" (0) position to
temporarily disconnect the cooling cycle. When the
beverage center is not to be used for a long period of
time, disconnect the plug and leave the door partially
open.
NOTE: Wait 3 to 5 minutes before restarting if
operation has been interrupted.
Fig. B
4
2
1
4
5