Defrosting The Appliance; Important - Danby Designer DCR032C1BSLDD Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
TEMPERATURE SELECTION
The temperature of the appliance can be adjusted
by turning the thermostat dial. The range of
temperature controls is from position "OFF", or no
cooling, to "7", the coldest setting. The setting "4"
should be satisfactory for home use.
EVAPORATOR DRIP TRAY
The evaporator drip tray is taped to the wire shelf
to protect it from damage during shipping. Before
using the appliance for the fi rst time, remove the
drip tray from the shelf and install it in the slots
under the freezer compartment. This tray will catch
any water that condenses on the evaporator and
may need to be emptied from time to time.
ICE CUBE TRAY
The ice cube tray is fl exible. Twist the tray to remove
the ice cubes. If the ice cube tray becomes frozen
solid to the surface of the freezer, run a little water
over the tray to release it. Never use a knife or other
metal instruments to remove the ice cube tray or ice
build up as this may damage the evaporator.

DEFROSTING THE APPLIANCE

This appliance should be defrosted approximately
every 6 months or whenever the layer of frost in the
freezer compartment reaches 6 mm (1/4") thick.
Remember to protect your fl oors during the
defrosting process by putting towels or a pan under
the appliance in case of leaking.
• Remove all food and set the thermostat to the
"OFF" or "0" position.
• Unplug the appliance and leave the door open.
• Ensure that the drip tray is under the evaporator
to collect melted water.
• After the frost has melted, discard the melted
water and leave the unit off with the door open
until the interior of the refrigerator is dry.
• After defrosting is complete, set the temperature
control to maximum for 2 to 3 hours before
returning to the desired temperature setting.
If the refrigerator will not be used for a long period
of time, disconnect the appliance from the electrical
supply and leave the door partially open. This will
help reduce mold and mildew build-up.

IMPORTANT

Never use sharp or pointed instruments to
remove ice from the freezer compartment.
The freezer compartment contains refrigerated
gas lines. If these lines are accidentally pierced it
will render the refrigerator inoperable and void
the manufacturer's warranty.
Do not allow the refrigerator to continue
operation if the freezer compartment is pierced.
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Designer dcr032c1bsldd-3

Table des Matières