Bluetooth - JVC KD-R981BT Manuel D'instructions

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone (supplied)
Microphone input jack
Adjust the
Secure using cord clamps
microphone angle
(not supplied) if necessary.
Pair and connect a Bluetooth device for the first time
1 Press (for KD-R981BT/KD-R784BT/KD-R782BT) or
turn on the unit.
2 Search and select "KD-R9
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) "[Device Name]" "XXXXXX"
KD-R782BT) or "ENTER – YES"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the volume knob (for KD-R981BT/KD-R784BT/KD-R782BT) or
KD-R889BT/KD-R881BT) to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
(B) "[Device Name]" "VOL – YES"
"ENTER – YES" "BACK – NO" (for KD-R889BT/KD-R881BT).
Press the volume knob (for KD-R981BT/KD-R784BT/KD-R782BT) or
KD-R889BT/KD-R881BT) to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. ( 16)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed and " " will light up when the Bluetooth
connection is established.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if you
reset the unit. To delete the paired device,
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio devices and switch
between these five devices. ( 17)
BT"/"KD-R8 BT"/"KD-R7 BT" on the Bluetooth device.
"VOL – YES" "BACK – NO" (for KD-R981BT/KD-R784BT/
"BACK – NO" (for KD-R889BT/KD-R881BT).
"BACK – NO" (for KD-R981BT/KD-R784BT/KD-R782BT) or
16, [DEVICE DELETE].
(for KD-R889BT/KD-R881BT) to
(for
(for
11
ENGLISH