z21 Roco FLEISCHMANN WLAN-MULTIMAUS WLANmaus Manuel D'utilisation page 64

Menus
3.4 "STOPMODE"
In the event of an emergency, press the STOP-key during drive mode to trigger an immediate emer-
gency stop. you determine the exact effect of the emergency stop in menu item "STOPMODE."
Use this menu option to define whether pressing the STOP-key disconnects the entire .system from
the mains power supply ("DISABLE VOLTAGE") or whether this only stops the locomotives ("EMER-
GENCY STOP"). Use the arrow keys to make a selection and confirm with OK-key.
Factory setting: DISABLE VOLTAGE
you can still trigger a "selective emergency stop" that only affects the selected locomotive in
spite of this setting. See page 49 for additional details.
Please note: should the radio signal be interrupted, a STOP can no longer be triggered using the
WLANmaus STOP-key . This is now only possible using the STOP-key of your Z21.
3.5 „INFOS"
A menu item that provides you with comprehensive information on the software and the battery
voltage of your WLANmaus.
„MOuSE-VERSION": The software version of your WLANmaus
„WLAN-VERSION": The software version of the radio module
„LANGuAGE-VERSION": the language version
„BATTERy VOLTAGE": displays the battery voltage in volts (V) that is measured at the time.
„WLAN"
3.6
3.6.1 „SSID"
Selection or entering of the SSID of the router that is to be connected to the WLANmaus.
"SEARCH": displays max. 8 of the strongest networks in the environment of the WLANmaus.
The desired network is selected by pressing the OK-key.
"ENTER": if the desired network should not be displayed with "SEARCH", you can enter it
manually here. The SSID that is in current use is also displayed here (please refer to the expla-
nations on the entering of characters, page7).
3.6.2 „PASSWORD"
This is where the password is to be entered. Pay great attention to the exact use of capitals/
small letters, special characters and spaces! The entered password is stored in the WLANmaus
after you have confirmed it with the
menu (please refer to the explanations on the entering of characters, page 7).
3.6.3 „Z21-IP-ADDRESS"
The IP address of the Z21 can be entered here, this means „Where does the mouse send its
commands to?" The pre-setting of the WLANmaus is conform with the pre-setting in your
Z21: "192.168.0.111". you only need to adapt the Z21 IP in the WLANmaus if you have
manually modified the IP of your Z21. Click through the four IP positions using the OK-key,
change the value using the arrow key or by using the number keys, you can cancel this by
using the STOP-key.
64
64
8010813920.indd 64
Display example: "4,12V"
OK-key. The password is no longer displayed in the
13.07.2017 10:27:50