Quick Programming - z21 Roco FLEISCHMANN WLAN-MULTIMAUS WLANmaus Manuel D'utilisation

Operation - Driving and Switching

2.6 Quick programming

The most important decoder settings for drive mode, known as configuration variables CVs, can be
made using the combination of MENu-key + function key.
CV Function
1 Locomotive address
Note: A change to this value has a direct effect on the decoder but not
on the locomotive library. The address saved there has to have the same
value as the CV.
2 Minimum speed
3 Acceleration
4 Braking time
5 Maximum speed
8 Resetting all decoder data to factory values (please read the decoder
manual).
Quick programming is possible in both library mode and locomotive address mode. All changes to
CVs 1–5 only have an effect on the locomotive in digital operation. It is basically possible to enter
values between 1 and 255 (locomotive address up to 9,999, read Part 3 "Menus" for details about
addresses above 100!). Since each decoder and each CV requires specific values, please consult the
corresponding decoder manual.
Example: To program the locomotive address = CV1 to value 4:
Input
52
52
8010813920.indd 52
Display message Comment
The display indicates the selected CV first (dis-
played as "C 1") and then switches to displaying
the read value. Values are not displayed in POM
mode (Part 3 "Menus").
Press one of the function keys to overwrite the
displayed CV value. The insertion point flashes.
Confirm by pressing OK-key. The WLANmaus
returns to train operation after the last display
("CV 1").
Note: After checking the CV1 of a locomotive,
check whether the address information of the
locomotive in the locomotive library is still cor-
rect.
keys
+
+
+
+
+
+
8 tuv
13.07.2017 10:27:47