z21 Roco FLEISCHMANN WLAN-MULTIMAUS WLANmaus Manuel D'utilisation page 60

Menus
2. The Menu „PROGAM"
All the values of a decoder (NMRA /DCC) are stored in what are referred to as configuration variables, the
CVs. using the "PROGRAM" menu you can adjust these values to your needs. Please consult the expla-
nations about "bits and bytes" listed in the glossary.
ROCO decoders already installed in locomotives are usually delivered with suitable settings. Check
before performing programming whether it is really necessary. See the instruction manual for your
decoder or locomotive.
The letter "C" on the display depicted during the readout/programming stands for "CV." However,
since the WLANmaus is also able to process 4–digit CV addresses, the "V" had to be dropped in the
display due to space restrictions.
Decoder data cannot be read out while in POM mode (see menu item 2.5). The display therefore depicts
either "NO CONFIRMATION" or there is no value displayed.
Any readout process that takes too long can be canceled at any time by pressing the STOP-key or the
OK-key. Once the text "uSER BREAK" appears in the display, you have two options:
▪ Press STOP-key to cancel the entire process and return to the start level.
▪ Press OK-key to cancel the readout process and open a value input dialog.
2.1 "CV MODIFICATION"
Read out CVs (please note menu item 2.5 as well) and enter new values. All DCC CVs between 1 and
1024 are programmable.
The first image of the display depicts a "C" and a flashing insertion point. Now enter the desired CV
(1 to 1024) using the function keys.
▪
Confirm with OK-key.
The depicted value is the actual true value of the CV. If you only wish to read the values, exit the
menu item with STOP-key. If there is no value displayed, the WLANmaus is in POM mode (see menu
item 2.5) and the locomotive is on the programming track.
▪ Now enter the new CV value (0 –255, CV1 1 –99, long addresses 100–9,999, see menu item 2.2)
and confirm with OK-key. The display switches briefly to "C..." with the digit of the corresponding
CV before you return to the "CV MODIFICATION" start level.
2.2 "LONG ADRESSE"
Only locomotive addresses from 1–99 can be stored in CV1. All locomotive addresses from 100 on-
wards must be programmed using this menu item. To do so it is first necessary to enable "long ad-
dresses" in the locomotive decoder using CV29 (Comply with decoder manual and menu item 2.3!).
When calling up this menu item, "CV 17/18" is briefly displayed. The display then switches to the
input option with the insertion field point and starting with "L" or the last saved long address also
starting with an "L." Now use the function keys to enter the desired address.
▪ Confirm with OK-key. The display switches briefly to "CV17/18" before you return to the "LONG AD-
DRESS" start level.
60
60
8010813920.indd 60 13.07.2017 10:27:49