z21 Roco FLEISCHMANN WLAN-MULTIMAUS WLANmaus Manuel D'utilisation page 50

Operation - Driving and Switching
Straight-on
The turnouts are switched over the moment you press on of the arrow keys. This also saves the turn-
out setting. The first free numbers after the "T" are set as "0" as confirmation (of course, for 1, 2 or
3 digit turnout addresses only).
The display of the turnout positions on the screen does not denote a response from the turnout
drive. The only way to check whether the turnout has actually changed is to check the turnouts
themselves.
If the position of the turnout on the system does not match the display, the connection plug of the
turnout must be turned by 180°.
you can now exit turnout mode by pressing the "Locomotive /turnout" key or call up and switch an-
other set of turnouts by entering the address.
If you call up another turnout address, the cursor and the entered number flash alternately until the
turnout has been switched using the arrow keys or you confirmed by pressing the OK-key.
Example: you wish to drive a locomotive (travel direction left) to branch off at turnout no. 24.
Input
Press the Locomotive /turnout-key again to return to drive mode (library or locomotive address mode).
50
50
8010813920.indd 50
Display message Comment
After the Locomotive /turnout-key has been
pressed, the WLANmaus switches from drive
mode (library or locomotive address mode) to
turnout mode.
The turnout last called up always appear. In this
case, turnout "6", position "straight-on.".
The flashing cursor indicates that the turnout
address can be entered. you enter the address
"24" using the function keys "2" and "4."
Press the right arrow key to switch the turnout.
You may hear an acoustic confirmation depend-
ing on the turnout drive in use. The vacant digits
between "T" and the address "24" are filled
with a "0."
Note: Pressing the key for a long time may
damage or destroy older turnouts which do not
have a cut-off.
Branch-on
13.07.2017 10:27:47