Using The Appliance - senya SYCK-HB006 Notice D'utilisation

 If the blades are blocked when mixing, always unplug the appliance before
removing the food responsible for blocking.
INSTRUCTIONS
I. BEFORE THE FIRST USE
Wipe the unit body with a soft, dry cloth and wash the blades with hot water and washing up liquid.
Rinse with clean water and dry carefully with a soft cloth.
TIPS FOR USING THE APPLIANCE
II.
The total quantity of ingredients and liquid must not go above the maximum limit (cold soup1.5 L, hot
soup 1.2 L). Any spillages may result in burns.
Ensure all ingredients are peeled, sliced or cubed (2-3cm)
If you are unsure of quantities, use the measuring plastic jug provided as a guide.
Always stir your ingredients before adding the lid, this prevents ingredients sticking to the bottom of
your soup maker.
Always remove the soup when the cycle is finished because the blender will still be hot and may burn
your soup.
If the control panel does not light up or if the blender does not start after it is switched on, check that
the bowl and/or cover (the tab on the cover must be aligned with the handle of the blender) are
properly positioned. Remove the blender or lid and position them correctly.
Do not heat/blend with the appliance empty.
Do not insert any utensils in the blender through the hole of the measuring cap.
Some operations cannot be performed properly with this blender: béchamel sauce, mayonnaise,
crushed ice
The appliance may be stopped during the cooking process by pressing the On/Off button

USING THE APPLIANCE

III.
This device is recommended for the following: creamy soup, blended soup, steamed
vegetables/meat/fish, smoothies, milkshakes, vegetable or fruit coulis, purées, fruit cocktails.

Ensure the soup maker is not connected to the power outlet
 Place the bowl (3) on the motor unit (1) (the blender does not work if the bowl is not properly
fitted).
 Chop all the ingredients into 2-3 cm chunks and place them in the bowl (3)

Finally, add the liquid using the graduated measuring cap (5) up to 0.8-1.5 L (Reminder:
maximum of 1.2 L for warm soup).

IN ORDER TO FUNCTION PROPERLY AND PREVENT ANY SPLASHING, NEVER GO
ABOVE 1.5 L OR BELOW 0.8 L OF LIQUID.
 Turn the lid clockwise until it locks in place and make sure that the tab on the lid is firmly
inserted in its slot.
 Plug the blender into the power supply. The On/Off button
ready for use.
USE OF THE MODES
IV.
31
.
flashes. Your appliance is