IMPPUMPS NMT Notice De Montage Et D'utilisation page 32

Key
Short press:
Scrolling through parameters upwards when not changing parameter values,
•
Scrolling through modes upwards when mode selection is selected,
•
• Changing parameters upwards when setting parameter values.
Long press:
• 3 seconds together with
• 5 seconds together with
5.1.1.2 TURNING ON AND OFF
On first start up the pump will operate with factory settings in automatic mode.
With subsequent start-ups, the pump will operate with the last settings that were set prior to its shut-down.
To switch the pump off, press and hold the
pump is switched off, the numerical display shows OFF.
To turn the pump on, press the
5.1.1.3 PUMP MODES AND PARAMETERS
For transition between modes, we hold the
pump to operate with
After confirming the mode, the parameter, which can be set, will automatically be displayed and blink (except
for auto mode). If necessary, we set the parameter value with
key or just press the
We can scroll through the parameters within a mode with
adjusted (see individual mode) in the mode with the
confirm the selected value with the
5.1.1.4 PUMP OPERATION LOCK
For locking and unlocking pump current pump mode and parameters, hold
the pump is locked, it is possible to turn the pump on and off, view parameters and reset the pump to factory
settings that also unlocks the pump.
puts us in night mode,
and keys to restore pump to factory settings.
key for 5 seconds, until OFF is shown on the display. When the
key briefly.
key for 3 seconds and then select the mode in which we wish the
or keys. We confirm the selection with the
key to accept the given parameter.
key.
key.
and keys, then confirm the setting with the
and keys. We select the parameter that can be
key and set the desired value with
32
and
and keys for 3 seconds. When
keys. We