Relay Output - IMPPUMPS NMT Notice De Montage Et D'utilisation

3.4.2.2 ANALOG INPUTS AND OUTPUTS (SET1,SET2,SET3)
Only available in variant NMT(D) SMART C. (Detailed description available in NMTC module manual, which can
be find on: :»http://imp-pumps.com/documentation/«, or with scanning QR code on the cover page.)
Connections can be used either as inputs or outputs, depending on how we set it. Pump has 3 connectors: SET1,
SET2 and SET3.
Input voltage
Output voltage
Input impedance
Input sink current
Galvanic isolation

3.4.2.3 RELAY OUTPUT

Only available in variant NMT(D) SMART S and NMT(D) SMART C.
Rated current
Maximum voltage
Maximum power
3.4.2.4 ETHERNET
Only available in variant NMT(D) SMART C. (Detailed description available in NMTC module manual, which can
be find on: :»http://imp-pumps.com/documentation/«, or with scanning QR code on the cover page.)
Connector RJ-45, 10BASE-T, 10 Mbit/s.
-Web server (port 80)
Services -Software update through web interface.
- Modbusa RTU through TCP/IP
Default IP address 192.168.0.245 (192.168.0.246 for right pump)
LED1
Ethernet visual
diagnostics
LED2
Electrical properties
–1 - 32 VDC When used as input.
0 - 12 VDC When used as an output. Max. 5 mA load on individual output.
~100 kΩ 0.5 mA additional load for most configurations.
0 - 33 mA Common sink on COM, if used as output.
Voltage 4 kV up to 1 s, 275 V permanent.
Electrical properties
Electrical properties
Slowly blinking if module is on. Lights up when the connection is established.
3 A
250 VAC, 30 VDC
300 VA
26