Spk 77; Connecting The Sensors; Connection Types Stationary Sce - ASO Safety Solutions ELMON inductive 77 Manuel D'utilisation

ELMON inductive 77 / SPK 77 Inductive signal transmission system
7.1 ELMON inductive 77
The housing of the ELMON inductive 77 allows the switching unit to be mounted in two different ways. It can
be snapped onto a 35 mm mounting rail, preferably located in a switching cabinet. If there is limited space
available on the mounting rail, the bolt-on feet can be cut off.
The housing can be directly mounted to a suitable base using four screws.
7.2 SPK 77
With the aid of the mounting bracket, the switching unit with the integrated stationary coil core is mounted
so that the cable can move through without problem during the gate movement.

8. Connecting the sensors

8.1 Connection types stationary SCE

Connection via plug-in screw terminals
Sight cap for 7-segment
display
ELMON inductive 77 E, ELMON inductive 77 R,
ELMON inductive 77 W
Connection via moulded M8 female connector
Connection via moulded cable with M8 female connector
ELMON inductive 77 E-KM, ELMON inductive 77 R-KM,
ELMON inductive 77 W-KM
26
Removable protective cap
for 7-segment display
SPK 77 E, SPK 77 R, SPK 77 W
SPK 77 E-M, SPK 77 R-M, SPK 77 W-M
SPK 77 E-KM, SPK 77 R-KM, SPK 77 W-KM