Battery And Battery Charger; Intended Use - Bosch GBH 24 V Instructions D'emploi

Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.

Battery and Battery Charger

The enclosed operating instructions for the
battery charger must be read carefully!
The battery and battery charger are designed
to match each other. When charging the bat-
tery, use only a Bosch battery charger de-
signed for it with a charging voltage that corre-
sponds with the battery (see type plate). Com-
bining different rated voltages causes damage
to the battery and the battery charger.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion! Do not place the battery on radi-
ators or expose to strong sun rays for a longer
time; temperatures over 50 °C cause damage.
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
Cover the contacts of a removed battery. Dan-
ger of fire results when shorted by a metal ob-
ject!
Do not dispose of the battery in household
waste or discard into fire or water.

Intended Use

The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic
and plastic. Machines with electronic control and
right/left rotation are also suitable for screwdriv-
ing and thread cutting.
12 • 1 619 929 558 • TMS • 15.02.02
Before Putting into Operation
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging /discharging
cycles.
To remove the battery 8, press the unlocking but-
tons 9 and pull out the battery downwards. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
Auxiliary Handle/Depth Stop
(see figure
Use the machine only with the auxiliary
handle 10.
Loosen the handle by turning to the left. Rotate
the auxiliary handle 10 and adapt to the working
position. Make sure that the clamping band 11 of
the auxiliary handle remains in the groove.
Firmly retighten the handle.
The drilling depth can be set with the depth
stop 3.
For this, press the push-button for the depth-stop
adjustment 4, adjust the required drilling depth X
and release the push-button for the depth-stop
adjustment 4 again.
The ribbing on depth stop 3 must point upwards.
English - 2
)
C