Gorenje GH10A-S Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
OPERATION
Use the high suction speed in cases of concentrated kitchen vapors. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately
after terminating cooking.
To switch the extractor light on or off
Press button A.
To switch on the extractor or to change the speed at any time when the extractor is running
• Press button C for the first, second or third speed level as required.
To switch the extractor off
Press button B.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching
off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the
fat filter) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
WARNING:
Failure to carry out basic cleaning recommendations of the cooker hood and replacement of the filters may
cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety
recommendations.
Filters
Grease metal filter
traps cooking grease particles. The grease filter must be cleaned once a month using non-aggressive
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a
dishwasher, the grease filter may discolor, but this does not affect its filtering capacity. To remove the grease filter, pull the
spring release handle.
Grease paper (synthetic) filter
the holes of the grille. The paper filter is colored on one side. This color should not be visible through the grille holes when the
filter is installed.
Charcoal filter
(filter version only) absorbs unpleasant odors caused by cooking. The saturation of the charcoal filter occurs
after prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is
necessary to replace the cartridge at least every four months. The charcoal filter may NOT be washed or regenerated.
Replacing lamps
The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration
up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.
For replacement, use only E14 LED bulbs.
Energy saving tips
1) When you start cooking, switch on the cooker hood at minimum speed, to control moisture and remove cooking odor
2) Use boost speed only when is strictly necessary
3) Increase the range hood speed only when the amount of vapor makes it necessary
4) Keep range hood filter(s) clean to optimize grease and odor efficiency.
26
Control Panel
A - Light button
B - Power off button
C - Speed level buttons
should be replaced at least every two months or whenever the color becomes visible through

Publicité

Table des Matières
loading

Table des Matières