INSTALLATION MANUAL
PCV123D (DGM1D)
Desktop and Handheld Mifare
Pass
loading
Badge number
0x123AD456
Blacklist updating
If management
with PC Software
Blacklist
saving
Validate
Cancel
Cardholders & pass badges management
The cardholders need to use a contactless smart card on the DGM1D. The cardholder badge is
programmed with a PCV123D Terminal unit which is also a Badge Enrollment unit.
The DGM1D controller has a site code which should be programmed before fi tting the system
on a door (default site code: 000000). To give access to cardholder on a DGM1D reader,
the site code of the controller must be programmed on the Cardholder badge.
The controller has a memory storage of invalid badges called « Blacklist » maximum
200 cardholder badges.
A lost badge must program in the « Blacklist » to invalidate the badge on the DGM1D reader.
Without the PC software:
All the code of the badges which have been programmed on the DGM1D reader must be
written on list so it would be possible to enter them in the « Blacklist » to refuse the access
on the reader.
With the PC software:
- The « Blacklist » can be stored in the Terminal unit and then downloaded on the PC.
cdvi.com
16
cdvigroup.com
terminal
®
Present a badge
Validate
Cancel
Confi rm
the updating
Confi rm
the updating
Scroll with the
arrows
or
Validate
Cancel
Scroll with the
arrows
or
EN