Sedus mr. 24 Mode D'emploi page 7

Healthy sitting is a question of attitude
Use the whole seat surface
®
The anatomically shaped seat should be fully occupied.
Only then is proper contact with the supporting back rest
assured.
mr. 24 is fitted with a sliding seat as standard. The seat
allows different sizes of people to use the chair.
Adjust the height of the seat precisely
®
The correct seat height means that the elbow joint
adopts an angle of about 90° when the forearms are
resting horizontally on the desktop. The knee joint
will also adopt an angle of about 90° when the feet
are flat on the floor. If your desktop is too high, and
cannot be lowered to a correct position, you need a
footrest with adjustable height and tilt.
Adjust the backrest
®
Adjust the height of the lumbar support so that the
curvature of the backrest supports the spine in the
region of the third and fourth lumbar vertebrae (where
the forward curvature is greatest). This stabilises the
natural S-shape of the spine in every sitting position.
mr. 24 has a multi-adjustable lumbar curve in order
to support the lumbar area.
Dynamic sitting
®
Dynamic sitting means changing your sitting posture
frequently, or in other words shifting as often as
possible between the front and rear sitting posture.
You should therefore adjust the backrest dynamically.
mr. 24 is equipped with a "Similar" mechanism,
allowing you to adjust the backrest pressure as best
suits you. This ensures that the backrest and seat
automatically give your body support in every sitting/
lying position.
English 7