Festool CTM 26 E Notice D'utilisation D'origine page 16

CTM
GB
Requirement: tool with operating pressure of
6 bar!
7.4 Adjusting the suction power

Use the rotary knob [1-10].
7.5 Applying the brake
Folding out the black brake lever [1-15] prevents
the mobile dust extractor from rolling. To achieve
this, lift the front end of the mobile dust extractor
slightly and push the black brake lever downwards
until it latches into place. Push the green lever [1-
14] again to release.
7.6 Temperature cut-out
A temperature cut-out switches the mobile dust ex-
tractor off when it reaches a critical temperature to
prevent overheating.

Switch off the mobile dust extractor, allow to
cool for about 5 minutes then switch on again.
 Not possible to switch on: contact Festool ser-
vice workshop.
7.7 Changing the filter bag (SC FIS-CT 26/
36/48)
Removing the filter bag [4]

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Remove the filter bag.

Dispose of the used filter bag in accordance with
statutory regulations.

Clean the dust container [2-3].
Inserting the filter bag [5]

Insert a new filter bag (SC FIS-CT 26/36/48) in
the inlet port of the dust container and interlock
it. Important: be aware that the locking engag-
es.
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s.
Possible causes
Value set on the suction power adjuster [1-10] is
too low.
Rotary knob [1-9] not set to the correct hose
diameter.
Suction hose blocked or kinked.
Filter bag full.
Filter element clogged.
Monitoring electronics malfunction.
Wet extraction.
16

Replace the top section [2-1] and close the
locking clips [2-2].
 Make sure that the filter bag is not pinched be-
tween the top and bottom sections.
7.8 Changing the disposal bag
Removing the disposal bag [6]

Close off the extractor opening [1-2] using the
sealing plug [1-1].

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Close the disposal bag.

Remove the disposal bag.

Dispose of the used disposal bag in accordance
with statutory regulations.

Clean the dust container [2-3].
Inserting the disposal bag [7]

Insert a new disposal bag (ENS-CT26/36/48) on
the inlet nozzle of the container and lock in po-
sition.
Important: The lateral openings on the disposal
bag must be positioned inside the container.
Make sure that the bolt engages.

Place the disposal bag over the edge of the con-
tainer.
Make sure that the contacts [10-2] are free.

Replace the top section [2-1] and close the
locking clips [2-2].
Solution
Set the suction power adjuster to a higher value (see
Chapter 7.4).
Set the knob to the correct hose diameter (see Chap-
ter 7.1).
Remove blockage or kink.
Insert a new filter bag (see Chapter 7.7).
Change the filter element (see Chapter 9.1).
Only AUTOClean: Clean filter element (see chapter
8.2).
Send to a Festool service workshop for repair.
Functional reliability not affected, no actions required.