Power Sources; Getting Started; Dab - Panasonic RF-D10 Mode D'emploi

rf-d10eg.book Page 4 Friday, January 3, 2014 4:54 PM

Power sources

Using the household mains socket
Connect the AC mains lead firmly to the unit and the
household mains socket.
Note:
• Do not use an AC mains lead from other equipment.
• This unit consumes a small amount of power when it is in
standby mode. Disconnect the power supply if you do not
use the unit.
Using the batteries (not supplied)
1
4
3
R14/LR14, C
Press towards
inserting the battery.
Use alkaline or manganese batteries.
Install the batteries so that the poles (+ and –) align with
those in the unit.
This unit will use the batteries as the power source when
you disconnect the AC mains lead. The battery indicator
will light up.
The battery indicator shows the battery levels.
Note:
• The unit switches on after you insert the batteries.
• When the battery indicator "
4 of the batteries.
• After the battery indicator flashes for 10 seconds, the unit
4
will switch off automatically.
4

Getting started

1
2
The first time you switch on the unit, it will enter DAB
mode and automatically scan for stations. It sets the time
and date (if data is available) and starts playing the first
station it finds.
Note:
In standby mode, the unit shows the time and date (only when
the unit is powered by AC).

DAB

DAB (Digital Audio Broadcasting) is a procedure of
broadcasting the radio digitally. It gives less interference
and better sound quality.
This unit supports DAB in "BAND III" bands.
DAB operation
The first time you enter DAB mode, or if the station list is
empty, the unit will start the full scan and memorise the
stations.
You can perform the full scan procedure when there is a
new station or a station becomes available.
1
2
█
2
This unit indicates those stations that are closed or no
longer available with a question mark in front of the
while
station name. You can remove these stations from the
station list.
1
2
3
" begins flashing, replace all
Extend the antenna.
Press [1] to switch on the unit.
Number of stations found
Press [BAND] to select "DAB".
Press [MENU] to select "Full scan" and then press
[ENTER] to start full scan.
To cancel, press [MENU].
Remove unavailable listed stations
Press [MENU] and then turn [ TUNE/SELECT
select "Prune".
Press [ENTER].
Turn [ TUNE/SELECT ] to select "Yes" and then
press [ENTER].
To cancel, select "No".
printing
] to