Cleaning Cutting Cover; Adjusting The Clutch Wire; Daily Maintenance; Weekly Maintenance - Husqvarna LC 48 Manuel D'utilisation

• Remove the protective cover by unscrewing the screws.
• Now guide the protective cover out and upwards.
• Clean the gearbox with a brush. Also check that the drive
belt and belt pulley are undamaged, for example, no cracks.

Cleaning cutting cover

• Connect a water hose to the cutting cover connection.
Scrape off the remainder with the scrape supplied with the
machine.

Adjusting the clutch wire

The clutch wire is adjusted by turning the adjustment screw.
Below you will find some general maintenance
instructions.
MAINTENANCE

Daily maintenance

1 Check that the engine brake handle works safely.
2 Brush leaves, grass and the like off of the lawn mower.
3 Check the oil level.
4 Clean the air intake on the starter. Check the starter and
starter cord.
5 Check that nuts and screws are tight.
6 Check the cutting attachment. Never use blades that are
dull, cracked or damaged.

Weekly maintenance

1
3
1 Clean the air filter. Replace if necessary.
2 Clean the spark plug. Check that the electrode gap is 0.51
mm.
3 Clean the cooling fins on the cylinder.

Monthly maintenance

1
3
1 Check that drive belt is not damaged and is not visibly
defective.
2 Clean the gearbox.
3 Check the fuel filter and the fuel hose. Replace if
necessary.
4 Clean the inside of the fuel tank.
2
2
4
English
– 89