Dubbing - Aiwa HV-FX8100U Mode D'emploi

Dubbing

Connecting with another VCR
HV-FX8100 (Recorder)
VIDEO AUDIO IN jacks
Red
White
Yellow
Audio/Video cable (not supplied)
Tips
• If the other VCR is a monaural type, connect one of the audio plugs only to AUDIO IN L (MONO).
• If you use this VCR for playback, connect the AUDIO/VIDEO OUT jacks on this VCR and the audio/video input jacks on the
recording VCR.
Note
If both units are turned on, made by AIWA and located near each other, do not use the remote control. Use the buttons on the
VCR instead.
Important
When you record a video signal output from this VCR onto another VCR, the indicators on the TV screen will be recorded on
the tape.
Operation
INPUT
w REC/OTR
a PAUSE/STILL
To audio/video
output jacks
Before starting
Select the tape speed.
1
Insert a pre-recorded source cassette into
another (playback) VCR.
2
Insert a blank cassette with its erasure
prevention tab in place into your HV-FX8100
(recorder).
3
Press INPUT to display "L" in the display
window.
You can also use the CHANNEL N or M button on
the VCR and remote.
4
Press w REC/OTR and a PAUSE/STILL on the
recording VCR.
5
Set the other VCR to play back.
6
Press a PAUSE/STILL on the recording VCR.
Another VCR (Player)
Video camera
(Player)
or
To audio/video
output jacks
26
ENGLISH