Aiwa HV-FX8100U Mode D'emploi page 26

Various search functions (continued)
Searching with the index function
— Index Search
The VCR automatically marks an index signal on the tape
each time recording starts. You can use these signals to
find the beginning of any recording.
Before starting
Set the VCR/CATV/TV selector to VCR.
Press INDEX + or – repeatedly during stop or
playback.
The unit starts searching.
Playback starts automatically from the beginning of the
specified recording.
Notes
• It is also possible to use the display window to check the
index numbers you specified. This is shown by "FF" or REW"
and the index number appearing in the display window.
• Index signals should be at least 3 minutes apart. Otherwise,
the unit cannot detect them properly.
• The Index signal may not be detected on damaged or worn
out tapes.
• The Index signal at the beginning of a recorded tape may not
be detected.
• The Index signal may not be detected if it is extremely close
to the point where the search began.
• When the tape reaches the end during Index Search, Index
Search will be stopped, the VCR will automatically rewind
the tape to the beginning, eject the cassette and turns the
power off (Auto rewind function).
19
ENGLISH
t+2
Searching the end of the recorded
program — REC. End Search
You can fast-forward/rewind the tape at the end of the
recorded program automatically.
Before starting
Set the TV VCR/CATV selector to TV VCR.
Press REC. END SEARCH during stop.
The unit starts searching.
REC. END SEARCH
Searching stops automatically after fast-forwarding or
rewinding as below;
Fast-forward
recorded
recorded recorded
Fast-forward
Press REC.END SEARCH
Previous recorded
later recorded later recorded
Fast-forward
Press REC.END SEARCH
Rewind
recorded recorded
Rewind (after
fast -forwarding
Stop
for a few secons)
Press REC.END SEARCH
To stop REC. End Search
Press s STOP on the remote control or s/z STOP/
EJECT on the unit.
Notes
• When the tape does not have blank space, searching stops
at the end of the tape.
• If from the point where REC. End Search begins there is less
than 5 minutes of recorded tape left in SP mode, 10 minutes
in LP mode or 15 minutes in EP mode, REC. End Search
may not work completely.
• If a tape has been recorded over in a different mode, either
SP or LP mode, then REC. End Search may not work
completely.
g
blank
blank blank
Stop
blank blank
Stop
blank blank