Connecting The Vcr - Aiwa HV-FX8100U Mode D'emploi

PREPARATION

Connecting the VCR

Basic connections
Caution
All connections should be made with both your VCR
and TV unplugged from the Power supply.
3
To AC outlet
AC cord
1
Disconnect the antenna cable from your TV and connect it to the UHF/VHF
IN (ANT) connector on this VCR.
If the cable is a round-type 75-ohm coaxial cable, connect it directly to the UHF/VHF IN
(ANT) connector.
If the cable is a flat-type 300-ohm twin-lead cable, connect it to the antenna adaptor
(not supplied), and connect the adaptor to the UHF/VHF IN (ANT) connector.
2
Connect the supplied antenna cable to the UHF/VHF OUT (TV) connector
on the VCR and the antenna connector on your TV.
If your TV has a 300-ohm antenna connector, use an antenna splitter (not supplied).
3
Connect the AC cord to the AC outlet.
To Connect a TV using the audio/video cable
If your TV has audio/video input jacks, you can connect the VCR and TV using the supplied
audio/video cable.
This connection improves the picture and sound quality.
75-ohm
coaxial cable
(not supplied)
UHF/VHF
IN (ANT)
OUT (TV)
Antenna cable
(supplied)
To antenna connector
OUT
VIDEO
L
AUDIO
R
Yellow
Red
White
audio/video cable (supplied)
300-ohm twin-lead cable
(not supplied)
Antenna adaptor
(not supplied)
1
Antenna splitter (not supplied)
2
TV
To UHF antenna terminal
CONTINUE
TV
UHF VHF
300-ohm
To VHF antenna
terminal
TV
To audio/video
input jacks
4
ENGLISH