Connecting The Vcr - Aiwa HV-FX9000U Mode D'emploi

PREPARATION

Connecting the VCR

Basic connections
Caution
All connections should be made with both your VCR
and TV unplugged from the Power supply.
3
AC cord
1
Disconnect the antenna cable from your TV and connect it to the AERIAL
connector on this VCR.
If the cable is a round-type 75-ohm coaxial cable, connect it directly to the AERIAL
connector.
If the cable is a flat-type 300-ohm twin-lead cable, connect it to the antenna adaptor
(not supplied), and connect the adaptor to the AERIAL connector.
2
Connect the supplied antenna cable to the RF OUT connector on the VCR
and the antenna connector on your TV.
If your TV has a 300-ohm antenna connector, use an antenna splitter (not supplied).
3
Connect the AC cord to the AC outlet.
To Connect a TV using the audio and video cables
If your TV has audio/video input jacks, you can connect the VCR and TV using the supplied
audio and video cables.
This connection improves the picture and sound quality.
(VHF/UHF)
To AC outlet
R AUDIO L VIDEO
OUT OUT
(MONO)
IN IN
LINE 1
Red
White
75-ohm
coaxial cable
(not supplied)
1
AERIAL
2
RF OUT
Antenna cable
(supplied)
TV
To antenna connector
To video
Yellow
input jack
Video cable (supplied)
Audio cable (supplied)
300-ohm twin-lead cable
(not supplied)
Antenna adaptor
(not supplied)
Antenna splitter (not supplied)
UHF VHF
300-ohm
To VHF antenna
terminal
To UHF antenna terminal
To audio
input jacks
CONTINUE
ENGLISH
TV
75-ohm
4