Dubbing - Aiwa HV-FX9000U Mode D'emploi

Dubbing

Connecting with another VCR
(Front)
LINE 2
VIDEO IN AUDIO IN L/R jacks
jack
Red
White
Yellow
Audio/video cable
(not supplied)
Important
When you record a video signal output
from this VCR onto another VCR, turn off
the on-screen display. Otherwise, the
indicators displayed on the TV screen will
be recorded on the tape.
Operation
wREC/ITR
aPAUSE/
STILL
HV-FX9000 (Recorder)
or
To audio/video output jacks
or
To audio/video
output jacks
Tips
• If the other VCR is monaural type, connect one of the audio plugs only to AUDIO IN
L (MONO) at the rear.
• If you use this VCR for playback, connect the AUDIO/VIDEO OUT jacks on this VCR
and the audio/video input jacks on the recording VCR.
Note
If both units are; turned on, made by AIWA, and located near each other, do not use
the remote control. Use the buttons on the VCR instead.
Before starting
Select the tape speed.
1
Insert a pre-recorded source cassette into another (playback) VCR.
2
0/INPUT
Insert a blank cassette with its erasure prevention tab in place
into your HV-FX9000 (recording) VCR.
3
Press 0/INPUT repeatedly to display "LINE1" (rear) or "LINE2"
CHANNEL
i/k
(front) on the TV screen.
You can also use the CHANNNEL i or k button.
4
Press w REC/ITR and a PAUSE/STILL on the recording VCR.
The recording VCR is in recording pause mode.
5
Set the other VCR to playback.
6
Press w REC/ITR or a PAUSE/STILL on the recording VCR.
Dubbing begins.
(Rear)
AERIAL
(VHF/UHF)
RF OUT
LINE 1
AUDIO IN L VIDEO IN jack
(MONO)/R jacks
Yellow
White
Red
Another VCR (Player)
Video camera (Player)
ENGLISH
24