Panasonic TY-ST85PF12 Manuel D'installation page 11

Assembly
4. Wiring the equipment to be connected
For details on how to install the equipment to be connected with the display or adding more equipment, refer to the
operating instructions of the plasma display and the operating instructions of the equipment concerned.
1. Insert 28 clamps  into rear of floor stand.
•8 on the inner edge of support  (Left)
•14 in support  (Right)
•6 in joint fixture 
2. If the equipment to be connected (such as an AV amplifier
and DVD recorder) is to be installed at the same time for
use, connect the plasma display wires first.
3. When wiring to connecting equipment, pull
wiring to the rear, using the mounted clamps.
Viewed from the rear, the left side is for cords
from connecting equipment, and the right side
for power cord and LAN cable.
(Follow the dashed line in the figure when using
LAN cable.)
Caution
•
If using LAN cable to connect plasma display, connect
the LAN cable so it is separate from other cables (this
does not include the power cord).
22
Joint fixture 
Support  (Left)
Support  (Right)
(LAN cable)
Power cord
Cords for connecting
equipment
Rear