EIBENSTOCK EPF 1503 Notice Originale page 17

If you don't relief the pressure on the machine or put
furthermore too much pressure on the tool it reacts by
witching OFF the machine.
of the machine you can
switching OFF and ON the power
Thermal: In case of permanent overload, a thermal sensor protects
the motor against destruction. In this case, the tool
switches off automatically and can only be restarted after a
certain cooling period (approx. 2 minutes). Actuate the
ON/OFF switch! The cooling period depends on the
heating of the motor winding and the ambient temperature.
Dust Exhaust
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a deduster and to wear a dust mask. For the EPF 1503 we
supply the industrial vacuum cleaners (category M) which can be connected
directly to the protective hood's 35 mm hose connector.
The machine is designed according to the requirements mentioned in
TRGS 559 (technical regulations for hazardous materials) article 4.3.
Care and Maintenance
Before the beginning of the maintenance- or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the power tool needs a minimum of care and
maintenance. The following works have to be carried out or rather the
component parts have to be inspected:
The power tool as well as the ventilation slots always have to be clean.
During work, please pay attention that no foreign elements get into the
interior of the machine.
In case of failure, a repair has to be carried out by an authorized
service workshop.
Our after-sales service responds to your questions concerning maintenance
and repair of your product as well as spare parts.
EIBENSTOCK's application service team will gladly answer questions
concerning our products and their accessories.
Environmental Protection
Raw Material Recycling Instead of Waste Disposal
After automatic switch-OFF
continue
17
working after
tool again.