EIBENSTOCK EPF 1503 Notice Originale page 15

First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate. Voltage differences from + 6 %
to – 10 % are allowed.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Switching on and off
Short-time operation
ON: Press the ON/OFF switch.
OFF: Release the ON/OFF switch.
Long-time operation (only for workings with Floor Guiding System)
ON: Keeping the ON/OFF switch pressed, push in the arrestor button.
OFF: Press and release the ON/OFF switch again.
Attention!
In case of every stop of the machine or a power cut, the
!
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
Change only the milling stars.
In case of damage, the capstan may be replaced only in an
authorized service centre.
Remove the three wing screws from the height adjustment (refer to
following section). Remove the brush rim and the height adjustment.
Open the Allen screw M8
The screws have a left-hand thread.
Holding the bush
washers . Put the new stars on. Fix the component parts referring to the
4
drawing.
Attention! Use only Allen screws with locking fastener.
Electrical Connection
Retooling
Attention!
Pull out the mains plug before retooling.
The cutting stars may be hot.
Wear protective gloves!
using the supplied size 6 Allen key. Attention!
1
2 for the capstan 5 with the stars
15
3 and the thrust