EIBENSTOCK EPF 1503 Notice Originale page 16

1 Innensechskant-
Allen screw M8
schraube
M8 links
Dust occurrence during milling may lead to sticking of the stars. This will
result in reduced milling performance and increased wearing.
Make sure that the stars are moving freely and, if sticked, unbind them
using a suitable tool (e.g. pliers).
Attention! The milling stars might be hot.
Height Adjustment
The EPF 1503 includes a height adjustable protective hood.
Overload Protection
In order to protect the user, the motor and the tool, the EPF 1503 is
equipped with an electronic and thermal overload protection.
Electronic: In case of overload caused by a grinding pressure
which is too high, the
speed of the machine. You can continue working when the
grinding pressure has been reduced.
2 Hülse
Bush
16
4 Druckscheibe
Thrust washers
3 Frässtern
Stars
1. Open the three wing nuts.
2. Pull the brush rim down till
the depth gauge can be turned.
3. Adjust the required milling
depth.
4. Push the brush rim up again.
5. Retighten the wing nuts.
electronics react by decreasing the
5 Fräskopf
Capstan