EIBENSTOCK EPF 1503 Notice Originale page 14

The tool must neither be wet nor used in humid environment.
Do not use the tool near explosive materials (petrol, dilution).
Do not work with materials containing asbestos.
Prior to every use, check the tool and its cable and plug. Have
damages only repaired by specialists. Insert the plug into the socket
only when the tool switch is off.
Plug and switch the machine off if it is not under supervision, in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
Before starting your work, check the proper seat of the cutting bit and
the individual stars.
Check the milling head before every use. Do not use damaged or
sluggishly running milling stars.
Make sure that the tool was mounted properly, and let it run idly in a
safe position for 30 seconds. Stop the tool immediately if you found
considerable vibrations or other defects.
Don't use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
After interruption of your work, restart the tool only after having made
sure that the milling head and the stars are moving freely.
Do not touch rotating parts.
Persons under 16 years are not supposed to use the tool.
Keep the handles dry, clean and free of oil and grease.
Caution marks!
Attention! The milling head still runs for a little while after the
machine was switched off.
When working with the machine, wear ear protectors, dust mask
and goggles.
Always hold the machine with both hands.
Consider the tool's reaction torque.
Make sure that persons in the work space are not endangered by
Particles flying around.
In order to avoid the star holder and the milling stars get damaged,
work very carefully on edges, corners or extreme transition.
Do not work on surfaces with steel reinforcements which lie open.
For further safety instructions please refer to the enclosure!
14